This Item is the Charger Only, and does Not require an EVCC (non-programmable). The charge profile is optimized for 150AH Lead Acid batteries but works with a wide variety of sizes.
For quicker charging, these can be wired in parallel. Input and output wire size must be rated for system current. Cooling fins and fan must have adequate clearance for cooling.
Charger Features:
- 48V nominal, Just plug in and charge!
- Charges to 59V with a float voltage of 54V
- 11" x 9" footprint and 11 pounds
- Water resistant to IP66 standards
- 25 Amps max out at 220 Volt input, reduced output at 110 Volt
- Draws <15 amps from 110V AC input
- TSM2500 Non-Canbus Charger
- Connectors with terminal pins:
- Anderson SB50 for DC Output
- 3-Wire AC input connector
- Charge Indicator Light with connector
- Thermistor Sensor with connector
- Charge Connector Diagram