Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

Throttle Controls

Throttles output variable low voltage based on throttle position, which is interpreted by the motor contoller as torque or speed information. The throttle selections offered by Thunderstruck are used for different applications depending on desired features, including:

  • FNR (Forward Neutral Reverse) capability, typically for marine applications
  • Cable to control arm attachment for existing remote throttle installations
  • Twist-grip or thumb activated, typcially used with motorcycles or off-road vehicles
  • Foot activated throttles, typically used for 4-wheel land vehicles 
  • Hall-effect (magnetic) or potentiometer (resistive "pot") type throttles

The Wigwag and ET series throttles listed below handle seamless forward and reverse operation in a single unit. The Wigwag is an electric remote throttle control, and the ET units can be either electric remotes or mechanically linked using your existing throttle control and cable. Making this selection up-front is very important because the motor controller must be programmed to match your throttle choice.

Please email us if you need help determining your specific requirements.

$11.00
This thumb throttle fits 7/8" handlebars and has a 5 ft cable.  Red 5v+ Black 5v- Yellow Signal 0-5v
+

[Contact us for a price]
*ITEM IS NO LONGER AVAILABLE The Currie Thumb Throttle fits on standard 7/8" handle bar and uses a 0-5k ohm potentiometer output to your controller....

$100.00
New Hall Pedal comes with mating connector.  throttle requires a 12v input, provides 0-5v output. Info Sheet Wiring for Pre August 2020 units
+

[Contact us for a price]
Price is $50 but these are on backorder This twist throttle is standard for almost all electric motorcycles. Reliable, simple, uses any custom grip....

$120.00
Domino Twist Throttle has 0-5K output and a microswitch. Includes matching grip and multipin connector. White> Low Black> Wiper Blue> High...
+

$150.00

+

$100.00
The Curtis PB-8 has a 3-wire design to accommodate controllers with a 3-wire input, but also can be used on all 2-wire configurations and has the same...
+

$35.00
This actuator arm allows you to attach your pre-existing boat throttle cable to the ET-134 or ET-126 throttles you purchase with your motor kit. Four...
+

$5.00
This knob can be attached to the ET-126 or ET-134 throttles, creating a simple hand-control actuator for your electric powered system.
+

$145.00

Hall Sensor Boat Throttle With Spring Return


$145.00

Hall Sensor Boat Throttle Without Spring Return


$160.00
A wigwag style throttle uses a potentiometer with 0-5K ohms resistance in one direction and 5K-10k in the other. It has a 3-wire connection to the...
+