This is an IPM water cooled motor for up to 96 VDC battery systems, and 250 amps continuous. This has the same stator and rotor as the ME1507, but in a water cooled IP67 case. Inlcudes a 7/8" keyed shaft. Provide your own small radiator and a coolant pump with a flow rate of 4-10 litres per minute. Max rpm 6000 Approx. 55 pounds. Motor speed will depend on controller type and settings.
When used in our kits, controllers will cut power when the motor gets too hot, based on internal motor temp sensor. Coolant temp leaving the motor should be under 230F/ 110C with standard use, and up to 100C on the inlet side is allowable. If controllers are adjusted for field weakening this rating would be lower. This is used with a Curtis controller for our sailboat and on-road use kits.
| Units | Motenergy ME1616 | |
| Type | Brushed/Brushless | Brushless |
|
Cooling Type |
Air/Liquid | Liquid |
|
Flow Rate Required |
liter/min | 4-10 |
| Voltage | Volts | Up to 100 |
| Peak Current | Amps | 600 |
| Continuous Current | Amps | 250 |
| Max Rotor Speed | rpm | 6000 |
| Torque (Peak Stall Torque) | Ft Lbs | 88 (120 Nm) |
| Torque Constant | Nm/Amp | 0.22 |
| Weight | lbs | 55 |
| Height (Not Including Cable Connection Points) | inches | 10 |
| Width | inches | 10 |
| Length | inches | 7 |
| Shaft Dimensions | Inches | 7/8, 1-11/16, 1/4 key |
| Efficiency | % | 92 |
| Poles | 5 pole motor (10 magnets) | |
| Inductance between phases (@1000 Hz) | micro Henry | 62-110 |
| Temperature Sensor Installed | Yes/No | Yes |
| Temperature Sensor PN | KTY84-130 | |
| Sensor Type | Sine-Cosine |