Throttle Controls

A throttle puts out variable low voltage based on throttle position, which is interpreted by the motor controller as either torque or speed information. Select your throttle based on your application and your desired features, specified below:

  • FNR (Forward Neutral Reverse) capability, typically for marine applications (WigWag or ET)
  • Cable to control arm attachment for existing remote throttle installations (ET or PB-8)
  • Twist-grip or thumb activated, typically used with motorcycles or off-road vehicles (Domino or Thumb Throttle)
  • Foot activated throttles, typically used for 4-wheel land vehicles (FP-6 or Hall Type)

The Wigwag and ET series throttles listed below handle seamless forward and reverse operation in a single unit. The Wigwag is an electric remote throttle control, and the ET unit can be either an electric remote or mechanically linked using your existing throttle control and cable. Making this selection up-front is very important because the motor controller must be programmed to match your throttle choice.

Please email us if you need help determining which is best for your specific requirements.

$160.00
A wigwag style throttle uses a potentiometer with 0-5K ohms resistance in one direction and 5K-10k in the other. It has a 3-wire connection to the...
In stock
+

$145.00

Hall Sensor Boat Throttle Without Spring Return

In stock

Minimum quantity for "Curtis ET-134 (Hall)" is 1.


$145.00

Hall Sensor Boat Throttle With Spring Return

In stock

$5.00
This knob can be attached to the ET-126 or ET-134 throttles, creating a simple hand-control actuator for your electric powered system.
In stock
+

$35.00
This actuator arm allows you to attach your pre-existing boat throttle cable to the ET-134 or ET-126 throttles you purchase with your motor kit. Four...
In stock
+

$100.00
The Curtis PB-8 has a 3-wire design to accommodate controllers with a 3-wire input, but also can be used on all 2-wire configurations and has the same...
In stock
+

$150.00
This Curtis-style throttle can be mounted in a variety of ways as the pedal can be rotated around the shaft. It is a potentiometer (potbox) throttle with...
In stock
+

$120.00
Domino Twist Throttle has 0-5K output and a microswitch. Includes matching grip and multipin connector.
In stock
+

$100.00
This is a single channel hall effect throttle with an internal idle switch. It  requires a 12v DC input, provides 0-5v output for motor controllers. Mating...
In stock
+

$75.00
These dual channel Hall throttles were removed from operating Coda EV systems. They require a 5 Volt supply, and provide variable outputs based on throttle...
In stock
+

$20.00
Replacement potentiometer for the Wigwag throttle.
In stock
+

$11.00
This thumb throttle fits 7/8" handlebars and has a 5 ft cable.
In stock
+