Curtis/ IPM System (32KW Brushless)

$2,675.00
32KW
+

*OUT OF STOCK UNTIL NOVEMBER

This system uses a high quality Curtis controller (48-80V) and the new Motenergy IPM motor for higher power brushless on-road vehicle systems. The Curtis allows better throttle response than the Sevcon controllers, forward and reverse drive, regen, and high efficiency power. Approx. 3500 rpm at 72v, but is dependent on actual voltage. 1236SE-6571 controller is rated for 450 amps peak with a 60 min rating of 185 amps continuous. Unless otherwise specified this will come programmed for a 72v nominal battery pack. 

Kit comes with:

Motenergy ME1507 IPM Motor or water-cooled ME1616

Curtis 1236SE-6571 Controller (96v systems available on special order)

Low voltage Wiring Harness

Tyco 48v Contactor

Domino or PB-8 Throttle

Engage II Display (Will show voltage, rpm, current, SOC, motor and controller temp, and fault codes)

 

Curtis controller programmers are available for OEMS or for rental only.

Motorcycle and Kart Installation Tips

Wiring Diagram

Curtis Fault Codes

I have purchased two of these systems through ThunderStruckEV. Couldn't be happier with the ease of setup and quality of parts & wire harness. The customer service and support is second to none. Thank you!
-Larry
Write a review