Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

Programmers

Ask us about programming your controller for you. Rates start at $50. Most but not all controllers will work off the shelf; if you have any questions, just ask! 

All handheld programmers available for rental - 2 weeks for $50

$10.00
Alltrax controllers use a standard RS-232 cable and free software available on the Alltrax website.
+
Add to wish list

$375.00
The Sevcon PCpak™ configuration system can be used to adjust parameters and reprogramming our Millipak PMAC and Millipak 4Q controllers...
+
Add to wish list

$250.00

The Sevcon Calibrator can be used to adjust parameters of our PMAC and Millipak 4Q controllers

+
Add to wish list

$375.00

The Sevcon Calibrator can be used to adjust the parameters of our PowerPaK controllers

+
Add to wish list

$850.00
PC-based programming software and dongle for Sevcon Gen4 Controllers. If you are trying to program your Gen4 to work with a different motor than it was...
+
Add to wish list

$450.00
Hand Held Programmer for Sevcon Gen4 Controllers. Not all parameters available in the PC based software are available on the handheld unit. Because of...
+
Add to wish list

[Contact us for a price]
THIS MODEL HAS BEEN REPLACED BY THE 1313 PROGRAMMER   The model 1311 LP Handheld Programmer simplifies the programming, testing...

$600.00 $450.00

The Curtis Model 1314 PC programmer works with all microprocessor-based Curtis controllers and chargers.


$455.00
The Curtis Model 1313 Handheld Programmer is a powerful and intuitive programming and diagnostic tool. Model 1313 enables parameter files to be created and...