Programmers

Ask us about programming your controller for you. Rates start at $50. Most but not all controllers will work off the shelf; if you have any questions, just ask! 

All handheld programmers available for rental - 2 weeks for $50

$850.00
PC-based programming software and dongle for Sevcon Gen4 Controllers. If you are trying to program your Gen4 to work with a different motor than it was...
+
Add to wish list

[Contact us for a price]
THIS MODEL HAS BEEN REPLACED BY THE 1313 PROGRAMMER   The model 1311 LP Handheld Programmer simplifies the programming, testing...

$600.00 $450.00

The Curtis Model 1314 PC programmer works with all microprocessor-based Curtis controllers and chargers.


$525.00
This controller is available to OEMs only. Please be prepared to provide documentation before shipment. Curtis 1313-4401 has New Features and an...

$450.00
Hand Held Programmer for Sevcon Gen4 Controllers. Not all parameters available in the PC based software are available on the handheld unit. Because of...
+
Add to wish list

$375.00
The Sevcon PCpak™ configuration system can be used to adjust parameters and reprogramming our Millipak PMAC and Millipak 4Q controllers...
+
Add to wish list

$250.00

The Sevcon Calibrator can be used to adjust parameters of our PMAC and Millipak 4Q controllers

+
Add to wish list

$300.00

The Sevcon Calibrator can be used to adjust the parameters of our PowerPaK controllers

+
Add to wish list

$10.00
Alltrax controllers use a standard RS-232 cable and free software available on the Alltrax website.
+
Add to wish list