Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

Luna Cycles 1000Watt Hub Motor Kit

Add to wish list

1000W Direct Drive Brushless DC Rear Hub Motor eBike Kit!


-Large, 10” diameter hub motor, built with 12 gauge stainless steel spokes into a 36 hole, double wall, alloy 6061-T6 26 X 1.75” rim (rim brake compatible). This hub motor utilizes standard 135mm spacing in the axle for easy fitment to most bicycle rear dropouts. The left side cover provides an ISO 6-bolt mount for disk brake, the right side has machined threads to accept a 1-6 speed freewheel.

The complete, built wheel weighs in at 16.5 pounds.

-Handlebar mounted control panel allows easy thumb access to the ON/OFF button and three power/speed mode selector button. A four LED State Of Charge meter is also integrated in the display.

-Sealed, weather-resistant 12 FET controller. This system is designed to work with any 48V *MAX 60V CHARGED* battery pack (batteries not included).

-Half twist throttle.

-Front and rear brake levers with cut-off switches. This is a safety thing, pulling either brake lever will cut power to the motor.

-PAS magnet ring and sensor.

Cost: $420.00

-The system draws ~25A @ 48V (nominal), so figure that momentary peaks of ~1500W at the wheel are possible.

L/M/H wheel RPM @ 48V-

L = 222

M = 365

H = 494

L/M/H MPH with 28.5” wheel @ 48V-

L = 13

M = 20

H = 25